Differences

This shows you the differences between two versions of the page.

--- parsec_autogen.com_and_a_sample_execution [2019/07/06 06:49] – created mmacgregor
+++ parsec_autogen.com_and_a_sample_execution [2019/10/23 18:28] – mmacgregor
@@ Line 1: / Line 1: @@
+====== Information ======
-This is a work in progress, it is not finished yet.
+The following document is a more user friendly method of using AUTOGEN.COM and being able to easily visualize the proposed changes.
 ====== Procedure ======
@@ Line 125: / Line 126: @@
   $ endsubroutine
-  CLASS3  > @parsec_autogen
+This is a sample run of the procedure:
+  $ @PARSEC_AUTOGEN
   @sys$update:autogen savparams setparams
   %AUTOGEN-I-BEGIN, SAVPARAMS phase is beginning.
@@ Line 145: / Line 148: @@
   Computed size: 25165800;  current size: 1404604
   %SYSGEN-I-EXTENDED, SYS$SYSROOT:[SYSEXE]PAGEFILE.SYS;1 extended
+        .
         Extending
             SYS$SYSROOT:[SYSEXE]PAGEFILE.SYS
@@ Line 151: / Line 154: @@
         high-water marking is currently enabled for this volume.  AUTOGEN
         will not extend the file further at this time.
+        .
         If your security environment allows you to temporarily disable
         high-water marking, the suggested commands are:
+        .
         $ SET VOLUME/NOHIGH SYS$SYSTEM
         $ MCR SYSGEN CREATE SYS$SYSROOT:[SYSEXE]PAGEFILE.SYS /SIZE = 25165800
         $ SET VOLUME/HIGH SYS$SYSTEM
+        .
         The system must then be rebooted in order to use the extended file size.
   Computed size: 3298481;  current size: 3206816
@@ Line 164: / Line 167: @@
   Computed size: 102000;  current size: 124000
   %SYSGEN-I-CREATED, SYS$SYSROOT:[SYSEXE]SWAPFILE.SYS;2 created
+  .
   ******************
   %AUTOGEN-W-REPORT, Warnings were detected by AUTOGEN.  Please review the
         information given in the file SYS$SYSTEM:AGEN$PARAMS.REPORT
   ******************
+  .
   %AUTOGEN-I-REPORT, AUTOGEN has produced some informational messages which
         have been stored in the file SYS$SYSTEM:AGEN$PARAMS.REPORT.  You may
         wish to review the information in that file.
+  .
   %AUTOGEN-I-END, GENFILES phase has successfully completed.
   %AUTOGEN-I-BEGIN, SETPARAMS phase is beginning.
   %AUTOGEN-I-SYSGEN, parameters modified
   %AUTOGEN-I-END, SETPARAMS phase has successfully completed.
+  .
   Press <RETURN> to review reports
   Parameter name            Old value  New value Difference    Default